Need help?Do you have a question about the Alicat Scientific MC Series and is the answer not in the manual?
Apply analog input to Pin 4 for setpoint or control.
Connect RS-232/RS-485 output signals to computer serial port.
0-5 Vdc output on Pin 6 for MC-Series controllers.
Default display showing pressure, temp, setpoint, flow rates.
Displays volumetric flow rate in selectable units.
Displays mass flow rate corrected to STP/NTP.
Accesses setpoint source, loop variable, and PID tuning.
Configures gas selection, device units, STP/NTP references.
Adjusts sensor settings, unit ID, baud rate, display settings.
Selects how the setpoint is conveyed to the controller.
Selects the PID control algorithm (PD/PID, PD2I).
Adjusts Proportional, Integral, and Differential terms of the PID loop.
Selects the gas or gas mix for accurate measurement.
Adjusts zero deadband and averaging parameters.
Explains error messages and how to resolve them.
Checks setpoint signal, grounding, and setpoint source.
Suggests PID tuning adjustment for slow response or oscillation.
Recommended yearly recalibration; contact for scheduling.
Details DB9 connector pinouts for PROFIBUS.
Explosion hazard warnings for CSA/ATEX devices.
General| Brand | Alicat Scientific |
|---|---|
| Model | MC Series |
| Category | Controller |
| Language | English |
To Next Page