FUNCTION VALUE:
BATTERY
Type: Ni-XX、Li-XX
Cell count: Auto or manual
LVC mode: Slow cut off/Hard cut off
THROTTLE
Throttle acceleration: Extra soft/Soft/Medium/Hard/Extra hard
Throttle Curve: Logarithmica, linear, exponential
Forwad/ Revervse Points: Auto or manual
Set Ini/End Points: Auto or manual
MOTOR
Motor Timing Degrees: (0% - °30%)
PWM: 8 - 16 – 32
Timing monitor: ON/OFF
Motor check: ON-OFF
Motor Rotation Direction: Clockwise/Anticlockwise
BRAKE
ABS Braking (car only): off -100%
PROP Braking (airplane-heli only): off -100%
Delay Time: 0.25 - 5 seconds (car and Boat only)
POWER
PWM Limit (Car/Boat): ON/OFF (%)
Reverse (car/Boat): ON/OFF
Start Power: Auto – 100%
HELICOPTER
Mode -HELI: Contant RPM/Normal RPM
Motor Pole set up: 2-4, 6-10, 12-14 (heli only)
Function value setting by transmitter:
This series of ESC can be set simply by transmitter, but more function value settings can only be done via
Program Box or PC via USB link. After connecting with ESC motor, receiver and battery, you can set the
function value
This series ESC can be set with some simple function value by transmitter, but the more function value
setting must be by prog-box or PC via USB link wire。
This ESC has two different types of mode, one is Brake ON mode, and another is Brake Off mode. Change
mode setting procedure as follows:
1. Move throttle stick on full power position, turn on transmitter. Now when switching on the ESC,
programming sequence will start.
2. Connect the power battery, turn on receiver.
3. After approx. 5 seconds, a four-tone melody can be heard; this indicates that a programming
sequence is ready.
4. You will hear 5 groups of beeps “♪ (a short beep)”, then 5 groups of 2 beeps “♪♪”, then 5 groups of
3 beeps “♪♪♪”; then 5 groups of 4 beeps“♪♪♪♪” ; and 5 groups of 5 “♪”， Each group of 5 sounds stands
for a different mode of ESC
5. You can put the throttle stick to the middle position during one group of 5 sounds, and then the
To Next Page
Loading...
Need help?
General