Align 3GX Compact - Page 22

Sensitive Forward/Aft/Left/Right
input response
SAT HOE RAR
Roll rate too high
RELERR
Problem Cause Solution
RR. RA He
Blade ina i Pitch linkage rod: t Adjust length of DFC ball link.
Tracking
=
On
length
ees
ADFC
SPARE
SATS
PITCH
BPRS
BEAT
Adjust DFC ball link to reduce pitch by 4 to
Excessive pitch 5 degrees. Hovering headspeed should be
EHEIRA PITCH BS around 1450RPM.
Headspeed too low IBH DFC PIRRE Pitch 4) + 4-518
ERE HE ( AROSE fie 927 734) 1450RPM)
Hovering throttle curve is too low Increase throttle curve at hovering point on
BERIMBRAE transmitter (around 60%)
Hover
ASR
ERDP
IDR
(
#9
60%)
kiii Adjust DFC ball link to increase pitch by 4
Not enough pitch to 5 degrees. Hovering headspeed should
be around 1450RPM.
Headspeed too high SERRMGQPITCH RE AE DFC HIRA Pitch 40+ 4-58
ERRBERS
(
ASOT
fie
92
75
784)
1450RPM)
Hovering throttle curve is too high Decrease throttle curve at hovering point on
PEBBAIBRAS transmitter (around 60%)
Drifting of tail occurs during hoveringRudder neutral point improperly set
or delay of rudder response when | gepisisoe7ay
Rudder centering rudder stick.
Response
Cee
a
bay
ged
Rudder
gyro
gain
too
low
TOREPE REEE *
RERE | EREMEMGRE” ARREINORRE
Tail oscillates (hunting, or wags) Rudder gyro gain
at hover or full throttle
PURE WP RAT ROI «
Forward/aft oscillation when the ELE gain dial on control box
elevator is applied counterclockwise, 10 degrees at a time until
FUPRARITAREDVEDS » RARATEEIED oscillation is eliminated.
IELAS LON A RRC RRS ENE ERA
Helicopter front bobbles (nods) BORSA BBS MMT
Oscillation
during flight or slack in control links | Replace servo, ball link, or linkage balls.
RIND WALU ENIRE HPH > RA
leron gyro gain too high Turn the AIL gain dial on control box
WRICRERS EELERRE counterclockwise, 10 degrees at a time
until oscillation is eliminated.
WIETE LOE DRS OME HEED + LLG
HOES: BRS wae
Worn servo, or slack in control links | Replace servo, ball link, or linkage balls.
PRB * BRMBRAS ERARE + MISHA + TRO
Helicopter pitches up during Elevator gyro gain too low Turn the ELE gain dial on control box
forward flight clockwise, 10 degrees at a time until drifting
Drifting ATLL ARICA S E is eliminated.
during flight WOE RBIS LON TRAC RE RENEA ERD
RTWB BO0EHSH ABSOSR
Aileron input causes helicopter to | Aileron gyro gain too low Turn the AIL gain dial on control box
drift clockwise, 10 degrees at a time until drifting
eye te ENEE is eliminated.
EOSO 3s LAVA ARRAS BENEA MAERA
BHUSHAN NESAS E
Slow Forward/Aft/Left/Right Roll rate too low Adjust roll rate within 3GX Flight Mode
input
response
ROBERE
setting.
Control MATSON MERRIE i a
Response
SFR
Adjust roll rate within 3GX Flight Mode
setting.
BE ICX RTHIREANRIRSA
If above solution does not resolve your issues, please check with experienced pilots or contact your Align dealer.
XPWRULABE DRESS SUMSLRILARSRORF SALSA AS -
21