SAFETY INSTRUCTIONS
O I G ITA L WATE R IO N IZE R
^ If the unit is immersed in water, immediately pull out the power
MIEII plug and then take the unit out of the water.
^
^
^
Try to avoid an electric circuit overload of an outlet or electric
wiring. Connect the unit power plug to an AC power outlet.
> Ensuring that the unit is connected directly to a power supply outlet
will avoid a circuit overload and reduce risk factor.
Do not touch the plug with wet hands when you insert or remove it
from a power outlet.
For a stable fit, plug in the power cord completely.
> If the plug fitting is not stable, it may emit electric shocks or cause a
fire due to overheating.
> Do not use a damaged plug or an unstable power outlet.
If the supplied cord is damaged, it must be replaced by the
X?Il manufacturer or a service agent. Please contact the business who
MBfiI sold you the product and refer to the manufacturer's warranty.
Do not install the unit in below-freezing
fire hazards.
> Correct room temperature range: 10 ~ 35oC
Correct inflow water temperature: 5 ~ 30oC
AK
temperature or near any ;'
- @
"O '
Do not install the unit in direct sunlight.
> Extreme environment exposure may cause the body of the exterior
unit to discolor and may cause the casing of the entire unit to
warp/twist. This may result in mechanical failure.
Always install the unit on a horizontally flat and sturdy surface.
\ a ~j/ Do not place heavy items on the top of the unit.
/
To Next Page
