ALL-O-MATIC SL-100 DC

Need help?

Do you have a question about the ALL-O-MATIC SL-100 DC and is the answer not in the manual?

Summary

Important Safety Instructions

Warning: Reduce Risk of Injury

General safety warnings and precautions for gate operator installation and use to prevent injury.

UL 325 Class Types and Obstruction Sensing Systems

UL 325 Class Types

Classifies gate operators based on intended use (residential, commercial, industrial, restricted).

Six Types of Obstruction Sensing Systems

Details six types of systems designed to detect and react to obstructions for safety.

Operator Specifications

SL-45 DC Specifications

Technical specifications for the SL-45 DC gate operator, including weight, length, motor, and speed.

SL-90 DC Specifications

Technical specifications for the SL-90 DC gate operator, including weight, length, motor, and speed.

Operator Specifications (Continued)

SL-100 DC & SL-100 DCFP Specifications

Technical details for SL-100 DC and SL-100 DCFP models, covering weight, length, motor, and speed.

SL-150 DC Specifications

Technical specifications for the SL-150 DC gate operator, including weight, length, motor, and speed.

Entrapment Protection Installation

Electrical Connection

Operators Must Be Properly Grounded!

Emphasizes the critical importance of proper grounding for gate operators to prevent electrical damage.

Power Connection Table

Gate Travel Adjustment

Limit Switch Adjustment Procedure

Step-by-step guide for adjusting limit switches to control gate travel limits.

SL-45, SL-90, SL-100 DC[FP] Limit Adjustment

SL-150 DC Limit Adjustment

SL-150 DC Clutch Adjustment

Clutch Adjustment Instructions

Procedure for adjusting the internal clutch on the SL-150 DC gearbox for proper torque.

Electronic Reversing Device (ERD) Adjustment

ERD Sensitivity Adjustment

Guidance on adjusting ERD sensitivity for proper gate reversal upon obstruction.

ERD Sensitivity Tuning Guide

Accessory Connections

Accessory Terminal Overview

Details the 12/24VDC terminals for powering accessories like loop detectors and keypads.

Jumper Removal for Safety;Stop CMD

Monitored Entrapment Protection Device Connections

Sensor Types and Wiring

Explains connection of non-contact (photo eye) and contact (edge) sensors for UL 325 compliance.

Enforcer, Allen Bradley, Omron, EMX Device Compatibility

MON_OPEN and MON_CLOSE Input Function

Describes the function of MON_OPEN and MON_CLOSE inputs and their corresponding LEDs.

Transmitter Solutions, Miller Edge Device Compatibility

Magnetic;Solenoid Lock Connection

Lock Installation Requirements

Explains the need for a step-down transformer for magnetic/solenoid lock installations.

Magnetic Lock Wiring

Instructions for wiring a magnetic lock to the control board's MAG relay output.

Solenoid Lock Wiring

Instructions for wiring a solenoid lock to the control board's SOL relay output.

Radio Receiver Connection

3-Wire and 4-Wire Receiver Connections

Explains how to connect both 3-wire and 4-wire radio receivers to the control box.

Radio Receiver Power and Relay Connections

Details power and relay contact wiring for 4-wire radio receivers.

Solar Panel Connection

On-Board Solar Regulator Function

Explains the on-board solar battery regulator with MPPT feature for efficient charging.

Solar Power Requirements

Emergency Release for SL-45 DC

Manual Opening Procedure

Emergency Release for SL-90 DC, SL-100 DCFP, and SL-150 DC

Manual Release Procedure

Foot Pedal Kill Switch Note