EasyManuals Logo

All-Power APG3002 User Manual

All-Power APG3002
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
3.5KWGenerator
ElectricalSafety
Grounded tools must be plugged into an outlet properly
installed and grounded in accordance with all codes and
ordinances. Never remove the grounding prong or modify
the plug in any way. Do not use any adapter plugs.
Grounding provides a low-resistance path to carry electricity away from
the user inthe event of an electrical malfunction.
Double insulatedtools are equipped with a polarized plug where one
blade is wider than the other. This plug fits in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install a polarized outlet. Do
not change the plug in any way. Double insulation eliminates the need
for the three-wire grounded power cord and grounded power supply
system.
Avoid body contact with grounded surfaces such as pipes, radiators,
ranges, and refrigerators. There is an increased risk of electric shock if
your body is grounded.
Do not expose generator to rain or wet conditions. Water entering a
generator will increase the risk of electric shock.
Do not abuse the power cord. Keep power cords away from heat, oil,
sharp edges, or moving parts. Replace damaged power cords
immediately. Damaged power cords increase the risk of electric shock.
When operating a power tool outside, use an outdoor extension cord
marked "W-A" or "W". These extension cords are rated for outdoor use,
and reduce the risk of electric shock.
All connections and conduits from the generator to the load must only be
installed by trained and licensed electricians, and in compliance with all
relevant local, state, and federal electrical codes and standards, and
other regulations where applicable.
The generator must be earth-grounded for fixed installations in
accordance with all relevant electrical codes and standards before
operation.
Do not attempt to connect or disconnect load connections while standing
in water, or on wet or soggy ground.
Do not touch electrically energized parts of the generator and
interconnecting cables or conductors with any part of the body, or with
any non-insulated conductive object.
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the All-Power APG3002 and is the answer not in the manual?

All-Power APG3002 Specifications

General IconGeneral
BrandAll-Power
ModelAPG3002
CategoryPortable Generator
LanguageEnglish

Related product manuals