Owner's Manual
Operation Fue_Tank
Electric
Start !
Oil Fill
3ontrol Panel
NOTE: THE PARTS LISTED ABOVE ARE HELPFUL FOR LOCATING THE CONTROLSMENTIONED BELOW.
CAUTION: Prior To First Using The Generator, The Engine
Must Be Filled With A High Quality SAE I0w-30 Grade Engine
Oil. To Do So Unscrew And Remove The Engine's Oil Dipstick
Located At The Bottom Of The Engine Crankcase. Fill The
Engine's Crankcase Until The Oil Level Is Level With The
Upper Marked Line On The Dipstick. Then, Screw The Dipstick
Back Into The Oil Fill Hole.
ENGINE OiL RECOMMENDATIONS
Oibis a majorfactor affecting performance andservice bife.Use
4-stroke automotive detergent oil
SAElOW 30 is recommended for generabuse.Other viscosities
shown in the chart may be used whenthe averagetemperature in
your area iswithin the recommended range.
BAE Viscosity Grades
-2_-1'' 1'02'°3'°4;°
AMBIENT TEMPERATURE
Before Starting the Generator
1. Check that the engine power switch is in its "OFF" position (see diagram on next page).
2. Before the first use, remove the fuel tank cap and fill the fuel tank with unleaded gasoline. When
fueling, be sure that the fuel strainer is in place. Replace the fuel tank cap. Thereafter, check
the engine's fuel gauge for the amount of unleaded gasoline in the fuel tank. If necessary, refill
the fuel tank with unleaded gasoline. The generator must be turned off and cooled down before
refilling the fuel tank.
7500W Generator
Operation (cont'd)
Starting
1. Turn the engine switch to the ON position.
The engine switch enables and disables the ignition
system.
OFF: To stop the engine
RUN: To run the engine
RUN ....
oF_
2. The fuel valve is located between the fuel tank and
the carburetor. When the valve lever is in the ON
position, fuel is allowed to flow from the fuel tank to
the carburetor. Be sure to return the fuel valve lever to
the OFF position after stopping the engine.
3.
To start a cold engine, move the choke lever to the
CLOSED position. To restart a warm engine, leave the
choke lever in the OPEN position.
The choke lever opens and closes the choke valve in
the carburetor.
The CLOSED position enriches the fuel mixture from
starting a cold engine.
The OPEN position provides the correct fuel mixture
for operation after starting, and for restarting a warm
engine.
2O
To Next Page
Loading...
Need help?
General
