8
1. Set the range switch to desire V range position.
Note: a. The range you select must be higher than the
battery's rated voltage.
b. If the magnitude of the battery's voltage is not
known beforehand, set the range switch to the
highest range position and then reduce it
range by range until satisfactory resolution is
obtained.
2. Connect the red test probe to the positive terminal of
the battery to be measured and the black test probe to
the negative terminal of the battery.
3. Read the reading on the display. The polarity of red test
probe connection will be indicated as well.
NOTE
1. Do not apply a voltage higher than 50V between the
test probes; otherwise the meter will be damaged.
2. When you measure battery, the red test probe must be
connected to the battery's positive terminal and the
black test probe must be connected to the battery's
negative terminal.
3. When you measure battery internal resistance, you
must connect the test probes to the battery directly. To
ensure measurement accuracy, do not use other lead(s)
for connection; otherwise the resistance of the lead(s)
To Next Page