37
EN
The heating is not controlled in stand-
by mode. The clock runs as normal and
programmed times and temperatures
remain in the memory.
Locking the keypad
The keypad can be deactivated to
prevent anyone touching the buttons
by mistake. This is shown with the lock
symbol in the display.
Press and navigate to LOCK. Conrm
with to lock.
Unlock by holding down both arrows
until the key symbol has disappeared.
Temperature
Displaying current temperature
(actualvalue)
Lock the keypad rst. Press . The light
will come on and the current tempera-
ture in the oor (F) is displayed in small
numbers above the desired tempera-
ture. This applies if the control function
is set on Floor thermostat, otherwise
the current temperature in the room (R)
is displayed instead.
The temperature is shown for 30 secs
after the last push of a button.
37
EN
To Next Page
Loading...