ALLECO 9750 - Page 42

40
Flashing green and red light – error
indication. The underoor heating is
turned o. The thermostat shows error
messages until it is switched o. Find
out more under Error codes.
No light – the thermostat is switched
o or is not getting any power.
Control functions
The thermostat can regulate the tem-
perature in three dierent ways. This ena-
bles the comfort temperature and any
ooring temperature requirements to be
combined. How you select the function
you want is described in the section How
to set the thermostat/Control functions.
Floor thermostat – A sensor in the oor
measures the temperature and then
regulates the heating accordingly. If
the oor sensor is connected when the
thermostat is turned on for the rst
time, this function is selected auto-
matically. Preset value is 22 °C.
Room thermostat – The thermostat has
two built-in sensors for measuring the
room’s temperature and controlling the
heating. The control function cannot
be selected when the oor sensor is
connected.
40