To Next PageTo Next Page
Need help?Do you have a question about the Allegro Industries 9806 and is the answer not in the manual?
Allegro AABA pumps are designed to pump clean, breathable air from an ambient source to NIOSH approved Type C, Continuous Flow Supplied Air Respirators.
Specifies the minimum requirements for Grade D breathable air, including oxygen levels and contaminant limits.
Instructions on how to adjust the pressure relief valve for proper air flow and pump operation.
Guidance on using the inlet extension kit to ensure clean air intake for the pump.
Specific operational tolerances and warnings for the air-driven pump model.
Guidelines and warnings for using the explosion-proof pump in hazardous locations.
Procedures and checks for inspecting all pump models, electrical motors, and air driven motors.
Information regarding thermal protectors on electrical motors and power source requirements.
Details on how the air coming out of the discharge port cools the motor and the use of PVC extension.
Recommendations for changing inlet and discharge filters based on running hours or pressure gauge readings.
Step-by-step guide for performing the pump flushing procedure using approved solvent.
Instructions for flushing the air-driven motor, including warnings about combustible liquids.
Guidance on lubricating the air motor with SAE #10 automotive engine oil.
Detailed steps for replacing vanes or inspecting the pump interior.
Lists common parts and accessories applicable to all Allegro pump models.
Specific parts and accessories available for the Allegro A-300 pump model.
Parts and accessories tailored for the Allegro A-750 and A-750TE pump models.
Parts and accessories for Allegro A-1500TE, A-1500EX, and A-4000AD pump models.
Specific parts and accessories for the Allegro A-3000ATE pump model.
Troubleshooting steps for electric motor issues including failure, starting problems, and noise.
Diagnosing and resolving issues where the pump or output air is excessively hot.
Identifying causes and solutions for an increase in outlet pressure, such as kinked hoses or filter issues.
Diagnosing and resolving issues with a drop in outlet pressure, checking filters and relief valve.
Troubleshooting low torque, speed, motor heat, or motor failure in air driven pumps.
General| Model | 9806 |
|---|---|
| Category | Oxygen Equipment |
| Manufacturer | Allegro Industries |
| Type | Oxygen Regulator |
| Flow Rate | 0-25 LPM |
| Duration | Dependent on cylinder size |
| Material | Brass |
| Inlet Connection | CGA 540 |
| Weight | 1.5 lbs |
| Outlet Connection | DISS 1240 |
