6 Rockwell Automation Publication 193-IN080A-EN-P - September 2018
E300 Electronic Overload Relay
2. Connect the E300 relay communication module to the E300 relay control module.
Be sure to secure this connection by pushing in the tab shown on the left side of the control module.
3. Install the I/O connectors.
Two of the I/O connectors attach to the bottom of the control modules. The third connector attaches to the top of the control module.
You have completed the assembly of the E300 relay.
Relay/Ground Fault Terminals
Power / Input / PTC
Terminals
Expansion Bus Connector
Sensing Module Latch
To Next Page
Loading...
