Publication 1404-UM001D-EN-E - October 2004
4-42 Communications
Figure 4.8 ControlLogix to Powermonitor 3000 Communication Tab Example
The first example below reads the Voltage and Current table from a
Powermonitor 3000 into the ControlLogix controller tag
dataPM3K_VI(0) using a PLC-5 Typed Read, configured as an array of
14 elements of type Real. You would configure a CIP Data Table Read
the same way except for the message type.
Figure 4.9 ControlLogix PLC-5 Typed Read Example
The next example shows the message configuration for a CIP Generic
message type. A CIP Generic message can read or write data,
depending on the Service Type you specify. Refer to DeviceNet class
services in the discussion above. In this example, the ControlLogix
To Next Page
Loading...