Publication 1404-UM001D-EN-E - October 2004
4-38 Communications
Ethernet PCCC/CSP protocol
PCCC messaging is supported in the Series A Powermonitor 3000 and
in Series B units with communications firmware 1.22 and Master
Module firmware 2.5x or later.
You may set up messaging from legacy controllers such as PLC-5 and
SLC 500, to a Powermonitor 3000 with optional Ethernet
Table 4.11 Ethernet Message Types
Message type Series A Series B
CIP PLC-5 Typed Write • •
CIP PLC-5 Typed Read • •
CIP Generic Assembly Object (class 04), Get & Set Attribute Single
for Attribute 3 (data)
••
CIP Generic Assembly Object (class 04), Get Attribute Single for
Attribute 3 (size)
••
CIP SLC 500 Typed Write •
(1)
(1) Available in communications FRN 1.21 or later.
CIP SLC 500 Typed Read •
(1)
CIP Data Table Read (using CSP/PCCC addressing e.g. F15:0) •
(1)
CIP Data Table Write •
(1)
CSP / PCCC PLC-5 Typed Write •
(2)
(2) Available in communications FRN 1.22 or later. Uses CIP Encapsulation on PCCC commands.
CSP / PCCC PLC-5 Typed Read •
(2)
CSP / PCCC Protected Typed Logical Read, 2 address fields •
(2)
CSP / PCCC Protected Typed Logical Read, 3 address fields •
CSP / PCCC Protected Typed Logical Write, 2 address fields •
(2)
CSP / PCCC Protected Typed Logical Write, 3 address fields •
CSP / PCCC Word Range Read
(2)
CSP / PCCC Word Range Write
(2)
CSP / PCCC Diagnostic Loopback •
IMPORTANT
For future compatibility, it is recommended that you
use EtherNet/IP messaging with Series A
Powermonitor 3000 units.
To Next Page
Loading...