SECTION 2
OPERATIONS
075705Page 32
Introduction to MSP445
This machine is built with user safety in mind. However, it can present hazards if improperly
operated and serviced. Follow operating instructions carefully.
If you have any questions about operating or servicing this equipment, please contact your Allen
Engineering Dealer or AEC Customer Service at 800-643-0095 or 870-236-7751.
• The MSP445X riding trowel is a modern high production machine. Finishing rate will vary
depending on the operators skill and job conditions. This riding trowel has ten finishing
blades.
• The Super Heavy Duty (SHD) Gearboxes are designed to provide exceptional performance
with low maintenance and trouble free use under some of the worst conditions.
• All Allen Engineering MSP445X Riders are equipped with a safety shutdown switch in the
seat and the throttle pedal, a low oil warning and a check engine light for added job safety
and engine protection.
• Operating time between fuel refills is approximately 2-1/2 to 3 hours with a rotor speeds of
165 to 185 RPM.
• The MSP445X Riders are the most technically advanced riding trowels on the market today.
With proper maintenance and use, your riding trowel will provide you with exceptional
service and dependability.
To Next Page
