Why is there spark but no flame in my Alliance Laundry Systems Dryer?
If your Alliance Laundry Systems Dryer shows a spark but no flame, verify that the gas is on and that there is 24 VAC at the gas valve. If 24 VAC is present at the gas valve, the control might be faulty. Check the voltage between the gas valve terminal MV and GND on the control.
What to do if the Alliance Laundry Systems Dryer valve is on but there is no spark during TFI?
If the valve is on but there is no spark during TFI (Trial for Ignition) in your Alliance Laundry Systems Dryer, consider these potential causes and solutions: * A shorted electrode may be the problem. Ensure the spark gap is correctly set between 0.094 and 0.156 inches. * A faulty high voltage cable or a poor connection can prevent spark. Check the high voltage cable. * A control failure can also cause this issue.
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | BA025E |
| Category | Dryer |
| Capacity | 25 lbs |
| Type | Tumble Dryer |
| Heat Source | Electric |
| Voltage | 208-240 V |
| Exhaust Size | 4 inches |
| Phase | 1 |
| Height | 43 inches |
To Next Page