To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems HFNNERSP116CW01 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | HFNNERSP116CW01 |
| Category | Washer |
| Language | English |
Read and follow all instructions before operating the machine.
Caution regarding hazardous voltage inside the unit.
Statements on compliance with FCC, IC, and EU directives.
List of washer models covered by this manual.
Explanation of the control's features and important notes.
Definitions of terms and abbreviations used in the manual.
How the control saves cycle status during power interruptions.
Details on Near Field, Serial Card Reader, and Network communications.
Description of pads for selecting water temperature for wash fill.
Description of pads for selecting cycle modifier options.
Explanation of Light Emitting Diodes and their functions.
Purpose of the 7-segment digits for displaying information.
Describes Power Up, Ready, Partial Vend, Start, End of Cycle, Door Modes.
Explains Partial Vend, Additional Vend, Start Mode, and Cycle Sequence.
Details Door Locking and Door Unlocking Modes during operation.
How to use Pause Mode and Delayed Start options.
Explanation of Auto Flush and Overflow Mode functionalities.
Description of Lockout and Shutdown modes for machine control.
Indication when a cycle was interrupted by power failure.
Features for programming control and collecting audit information.
Running diagnostic tests and clearing vend features.
Rapid Advance, Communications, Coin Drop, Start Pulse, Service Door access.
Break-In Alarm, Special Vend, OPL Mode, Drop-Off Mode, Low Power/Auto-Shutdown.
Out of Order Mode, Network Node Number Display, Error Display Mode.
Instructions for opening service doors on different washer models.
Procedure for accessing the control panel on 45 degree models.
Steps to enter Manual Mode and navigate its groups.
Overview of programmable features and options.
List of available programmable options and their settings.
Flowchart for programming vend prices and payment configurations.
Flowchart for programming error codes and fill step types.
Flowchart for drain errors, water leak detection, and slow drain.
Flowchart for suds errors, overflow, and water level settings.
Flowchart for setting real-time clock and daylight savings.
Flowchart for programming Special Vend 1 parameters and prices.
Flowchart for programming cycle modifier options and defaults.
Flowchart for programming individual cycles and custom messages.
Flowchart for programming balance attempts, pause resume, and power settings.
Flowchart for programming lucky cycles, speed units, and OPL settings.
Methods to enter and exit the audit feature.
Procedure to view stored audit data from the control.
Steps to reset the washer control to factory default settings.
How to enter, start, and exit diagnostic tests.
Chart summarizing diagnostic tests, modes, and display outputs.
Tests for software versions, door, coin, and vend header status.
Tests for coin drop functionality and vend connection status.
Tests for start pulse, door switches, fill time, drain time, and out of balance.
Tests for external outputs, water purge, and water leak detection.
Tests for water level, voltage, and machine configuration.
Steps to enter and exit the Factory Test mode.
Chart of display outputs and test modes during Factory Test.
List of error codes for payment systems and general machine errors.
Error codes related to network, water leaks, and speed failures.
Error codes for fill issues, door lock/unlock, and load balance.
Error codes for board issues, voltage configuration, and communication failures.
Error codes for slow drain, suds lock, water leak, and no water flow.
Error codes for pressure sensor, trim, and broken belt issues.
How to enter and exit the Rapid Advance feature.
Procedure to clear vend price and reset to ready mode.
How the control maintains cycle status after power interruptions.
Details on NFC, Card Reader, and Network communication features.
Default programmed cycle times for various wash steps.
