What to do if the Collision LED is flashing excessively on my Allied Telesis AT-3012TR?
If the Collision LED is flashing excessively, this may indicate too many frame collisions on the segment. Ensure that the SQE/Heartbeat Test function is disabled on the transceiver attached to the AUI port. You can also try using a known good repeater to test and validate the segment.
What to do if Port OK LED is not lit on Allied Telesis AT-3012TR?
If the Port OK LED is not lit, verify that the device at the opposite end of the UTP link is powered on and that the cable is properly connected. Also, check that the proper cable pin-out is used. If another manufacturer’s 10BASE-T device is used on the opposite end of the UTP link, ensure that it is true 10BASE-T.
How to troubleshoot a Allied Telesis Repeater when the Power LED is not lit?
If the Power LED is not lit, check your power connections to ensure they are properly connected.
General| Brand | Allied Telesis |
|---|---|
| Model | AT-3012TR |
| Category | Repeater |
| Language | English |
To Next Page
