17
Connecting to the host computer
To connect the camera to the host computer, we recommend using a
Category 6 cable or higher.
Launching the applications
Step 1: Power up the camera and wait until the boot phase is complete (see
above).
Step 2: Launch the Vimba Viewer application and wait for the camera to
appear in the Detected Cameras list. This may take a few seconds,
depending on the number of cameras connected to the PC.
Step 3: Select the desired camera from Detected Cameras list.
Step 4: A new camera window appears, as shown in the screenshot on
page 17
To Next Page
Loading...
