Allmatic AM1 PAD - Page 16

4 / 12 - English 6-1622780 - rev.4 - 02/08/2021
Change MASTER CODE
Enter programming mode .
Select menu 3 by pressing
O
Enter the new 4 digit master code twice.
O
Exit the programming mode .
Reset default MASTER CODE: "1234"
Disconnect keypad power supply.
Press and maintain pressure while reconnecting power until you hear the sound signal.
G
Reset factory settings
Clear all codes and cards and reset master code ("1234").
Enter programming mode .
Select the menu by pressing
O O
Create MASTER CARD
The MASTER CARD allow to enter programming mode.
Enter programming mode .
Select the menu 7 by pressing
G O
Pass the MASTER CARD.
O
Exit the programming mode .
Delete or change MASTER CARD
Enter programming mode .
Select the menu 7 by pressing
G O
To replace registered MASTER CARD press
G O
KEY:
O
= LED Orange;
G
= LED Green;
R
= LED Red; = LED flashing
= Small sound; = Long sound