Putting the Hub in Learn Mode
The Alloy SmartHome Hub can be put in Learn Mode in order to add it to another controller's
network as a secondary controller. This is useful when performing tests on the Hub.
Please note that the moment the Alloy SmartHome Hub becomes a secondary controller, it falls
under the control of the primary controller. Until the Hub becomes primary again, the Alloy
SmartHome Hub Web application is no longer functional.
You put the Hub in Learn Mode with the small button on the Hub itself (just above the
LED light).
© 2020 Alloy SmartHome LLC All Rights Reserved 12
To Next Page
Loading...
Need help?
General
