SETUP
Windshield Mount Installation
Step 1: Find a safe location on the interior of the vehicle’s windshield to mount the pedestal. Make sure the windshield is clean and dry. Firmly push the suction cup base (A) against the
windshield and ip the base lever down (B) to the locked position (diagram 1).
Step 2: Adjust the angle of the pedestal arm by tightening the adjustment knob (C) at the base to the desired angle (diagram 2).
Dash or Console Mounting
Step 1: Find a safe location on the dash or console. Clean the mounting surface if necessary. Remove the paper backing on the adhesive disc and rmly press in place (diagram 3).
Step 2: Place the pedestal’s suction base (A) over the center of the circular disc. While rmly holding the pedestal on top of the disc, ip the base lever down (B) to the locked position.
universal hands-free mount
™
securely holds mobile devices | tient solidement les dispositifs mobiles
diagram 1 diagram 2
diagram 5
diagram 3
Mobile Device Installation
Step 1: Remove protective lm.
Step 2: Check Clingo pad for cleanliness and stickiness before each use. Product will fail if the pad is not cleaned properly.
See PROPER CARE & CLEANING for instructions. Cleaning frequency may vary by environment.
Step 3: Wipe dirt and dust from your mobile device and attach it to the Clingo pad. DO NOT attach your mobile device to
the Clingo pad if it is protected by a leather or silicone case. The Clingo pad WILL NOT stick to leather or silicone.
Make sure the device is placed on the pad so that the battery cover does not slide o.
Step 4: Adjust the angle of the cradle to nd the optimal hands-free viewing position.
Removing Mobile Device
Gently peel (do not pull) your device o of the Clingo pad from the top edge (diagram 4).
PROPER CARE & CLEANING
Proper care and use of the product is necessary to maintain optimal stickiness on Clingo pad.
For Best Results
Step 1: Always remove mobile device from Clingo product.
Step 2: Run warm water over Clingo pad and use ngers to remove dirt and dust. Hand oils and grease may require the use
of mild soap. DO NOT use solvents to clean the Clingo pad.
Step 3: Let Clingo pad air dry completely before using. The Clingo pad WILL NOT stick when wet.
For Quick Cleaning
Step 1: For quick cleaning, use a damp, lint-free wipe or cloth to remove dust, dirt and oil from Clingo pad (diagram 5).
DO NOT use any paper products.
CLINGO PAD
The Clingo pad is permanently bonded to the product. Do not attempt to remove the Clingo pad.
Safety Precautions
Do not install Clingo products over an air bag cover or within the air bag deployment zone. Allsop, Inc. and
its subsidiaries assumes no responsibility of liability for injury or death as a result of car crashes and/or air
bag deployment. Allsop, Inc. and its subsidiaries are not responsible for any damages caused to your car, your
device, or yourself due to installation or use of this product
C
B
A
diagram 4
! WARNING
Do not install Clingo products over an air bag cover
or within the air bag deployment zone
! WARNING
An Family Brand
PO Box 23, Bellingham, WA 98227
PH 360-734-9090
www.allsop.com
ALLSOP Europe Limited,
Industrial Park, Waterford, Ireland
PH 353-51-355091
www.allsop.eu
for more information, visit www.clingo.com
To Next Page
Need help?
General
