WrapCaddy | Model # 32194 | 191115
For Technical Support, visit digitalinnovations.com
Packaging Contents
Wrap Caddy base
hook+loop strap
(2) hook+loop mounting strips
Fits devices that do not exceed
maximum dimensions
©2020 Allsop, Inc. Bellingham, WA | info@allsop.com | 1-800-426-4303
The hook and loop strap (B) is installed with the
loop (soft) side to contact your streaming device.
Determine mounting location and choose a mounting option:
a. Back of TV: hook+loop mounting strips
b. Wall behind TV: screws (not included)
c. TV mount: cable tie (not included)
Place your streaming device in the center of base (A) and secure with strap (B)
Wrap cables around the
corner tabs to eliminate
slack and prevent pinching.
(Optional - for advanced users only)
While holding the device, open the
strap (B) and thread it around the
cables to secure them.
C
B
A
B
C
A
1
2
3
4
The WrapCaddy is designed to fit most streaming devices. If your
device is too large, or if your remote control requires line-of-sight
visibility to function, then we recommend using WrapCaddy™ only
as a cable organizer.
Note
With hook and loop (C) joined, remove backing from the hook
(hard) side and adhere to the recessed patch on the back of the
base (A). Repeat for other side. Remove the backing from the loop
(soft) sides and place the Wrap Caddy™ on the back of the TV on
a flat region. Press firmly for 10 seconds to ensure a strong bond.
You may now remove the base for minor repositioning or for
spooling cables (see step 2).
Use the 2 screw holes on the
base (A) to join to the TV mount.
Use the 2 screw holes on the base (A) to mark
and drill the wall. Screw in the screws and then
use the keyholes to mount. 4-40 ½ in.
countersunk screws recommended.
Streaming Device + Cable Organizer
Wrap Caddy
™
Streaming
device
3.75 in.
5 in.
5 in.
< 8 in.
To Next Page
Need help?
General