Allstar Innovations ICE GENIE User Manual

Step 2: Fill water into the channel at the top
of the Outer Chamber. Fill until water reaches
just above the top row of cubes.
*Be careful not to put water directly into the
Inner Chamber.
Note: Pour out any water that overflows into
the upper part of the channel.
USING THE ICE GENIE
™
ICE CUBE MAKER
Step 1: Insert the Inner Chamber into the Outer
Chamber, creating a seal. Feel around the base of the
Outer Chamber to see if the Inner Chamber is
properly seated.
IMPORTANT SAFETY INSTRUCTIONS:
• Only use Ice Genie™ Ice Cube Maker as described in this manual
• Always store in a clean, dry place when not in use
• Ice Genie™ Ice Cube Maker is top rack dishwasher safe
• Keep away from extreme heat
• Ice Genie™ Ice Cube Maker is NOT microwave safe
For more tips and instructional videos, visit: www.IceGenieTips.com
INSTRUCTION MANUAL
COMPONENTS
Step 1
Step 2 Step 3
Step 3: Snap the Lid onto the Ice
Genie™ Ice Cube Maker.
Place into freezer upright until all
the water is frozen (4-6 hours).
Inner Chamber Outer Chamber Lid
Fill to
this point
Channel

Allstar Innovations ICE GENIE Specifications

General

Brand	Allstar Innovations
Model	ICE GENIE
Category	Kitchen Appliances
Language	English

Summary

Important Safety Instructions

Components Overview

Using the Ice Genie Ice Cube Maker

Step 1: Chamber Insertion

Insert the Inner Chamber into the Outer Chamber, creating a seal. Ensure the Inner Chamber is properly seated.

Step 2: Filling with Water

Fill water into the channel at the top of the Outer Chamber until it reaches just above the top row of cubes.

Step 3: Freezing

Snap the Lid onto the Ice Genie Ice Cube Maker and place it into the freezer upright until frozen (4-6 hours).

Step 4: Initial Removal

Once frozen, remove the Ice Genie Ice Cube Maker from the freezer, remove the Lid, then squeeze the Outer Chamber.

Step 5: Lid Placement

Place the Lid centered directly under the Outer Chamber.

Step 6: Breaking Free

Grip the edge of the Outer Chamber, push down to break free. Twist and pull handles upward to remove Inner Chamber.

Step 7: Ice Release

Squeeze the Outer Chamber to release all ice cubes. Ensure cubes are pushed out of cavities before reinserting.

Additional Batches of Ice

Prepare for Next Batch

Remove ice cubes, place them into the Chamber. Insert the Inner Chamber back into the Outer Chamber.

Refill and Repeat

Refill channels with water, leaving existing cubes. Repeat steps 2-7 for multiple batches (up to 72 cubes).

Cleaning Instructions