Alltrax XCT - Finalizing Settings and Usage Scenarios; Setting Mild Mode for Child Use; Programming Controller with SET Button

P/N: Doc113-016-A_FN2-XCT_Operators-Manual Page 4 of 4
© Alltrax Inc. 2016
All Rights Reserved
Alltrax FN2 for XCT Controllers
When the kids come over, set the box for mild mode. Then they can’t get into too much trouble.
Once you have your settings configured – PRESS SET to program the controller and you’re all done!
If you have any feedback or comments for these instructions, please email info@alltraxinc.com as we value our
customers input, we make feature rich performance products based on our customers input.
Made in USA
Min / Max Regen and speed
are reduced for “Child Mode”
SET
Button