P/N: Doc113-016-A_FN2-XCT_Operators-Manual Page 1 of 4
© Alltrax Inc. 2016
All Rights Reserved
Alltrax Inc
1111 Cheney Creek Rd
Grants Pass, Or, 97527
Direct: 541-476-3565
Fax: 541-476-3566
Alltrax XCT Function Knob Boxes: FN2 for
XCT REGEN Motor Controllers
File: DOC113-016-A_FN2-XCT_Operators-Manual.pdf, Released Rev A, EC-051216
ALLTRAX PN: FN2-XCT
The XCT motor controllers have “User Inputs” or commonly called Personality Switches that allow for set user
profiles or interactive adjustments of Speed or Regen while driving. XCT Controllers PRIOR to AUGUST 2016 may
not have the FN 3-pin integrated connector in J4-J5-J6 connector well (See WEB SITE for serial number cutoff). An
adapter kit for all older controllers taps into the carts wire harness.
Use TOOLKIT software (Version 3.0 or above) to enable the new Function Control features. Newer XCT controllers
built ON or AFTER August 2016 will have the 3-pin connector to directly plug the FN boxes into the XCT controller
J4-J5-J6.
Dual Potentiometer
Pre-August 2016 with adapter wire harness
August 2016 with Integrated J4
To Next Page
Need help?
General