10 EN
Channel
Channels: Display the scan sub-menu based on different channel installation modes.
Channel installation mode: Select on-screen display channel sources. You can select
the signal type.
•Antenna: Set the signal type to antenna. When set to Antenna, the TV can receive
analog and digital (DVB-T/DVB-T2) broadcasting signals.
•Cable: Set the signal type to cable. When set to Cable, the TV can receive analog
and QAM broadcasting signals.
Auto Channel Update
Parental controls: Press▼▲buttons to select the option then press OK to enter the sub-menu.
Audio Channel: Press▼▲buttons to select the option then press OK to enter the sub-menu.
Open source licenses: Press▼▲buttons to select the option then press OK to enter the sub-menu.
Antenna
1. Menu->Settings->Channel->Channel Installation Mode->enter, choose Antenna or Cable.
2. Enter Menu->Settings->Channel->Channels.
3. Channel Scan directly enters the ATV+DTV automatic search platform interface of Antenna.
Update Scan: Re-automatically search for frequency points outside the station.
Analog Manual Scan: Manual ATV search station. After you input the frequency point, you can select up or
down to search for a station.
Single RF Scan: DTV manual search, left and right after selecting RF Channel, directly OK search.
To Next Page
Loading...
