What to do if Fault LED lights red on Alnico 3 Series?
If the Fault LED lights up red, the LCD shows an error, or the Internet manager signals a fault with your Alnico Storage, you should immediately figure out why. Check the component LEDs for any faults and replace the faulty component as quickly as you can.
Details the different Alnico RAID subsystem models, host interfaces, and drive bays.
Lists the key features, capabilities, and supported RAID levels of the Alnico series.
Safety guidelines for handling components to prevent electrostatic discharge.
Step-by-step guide for installing hard disk drives into the subsystem bays.
Instructions for mounting the subsystem into a standard 19-inch rack.
Details on connecting cables and power for system integration.
Procedure for removing and installing the RAID controller component.
Guide for installing or replacing memory modules (DIMMs) in the subsystem.
Instructions for replacing fan modules while the system is operational.
Instructions for replacing power modules while the system is operational.
To Next Page
General