OPTIONAL 6, 2, 440MHz ADD-ON ELEMENT: See https://youtu.be/LJ0Hx0nHLXE Installation - a) Remove the t-
connector from the small inner feed loop. b) Re-connect the t-connector to the coax end that has a soldered pin in
its’ PL259. c) On the PL259 without the soldered center pin, attach the barrel connector of the 6M, 2M, 440MHz
add-on element. d) Form a single loop with these coaxial elements. e) secure the end of the add-on element to the
coax of the inner loop using a nylon coax clip. f) Tune by sliding the element in and out of the nylon coax clip.
To Previous Page
Loading...
