EasyManua.ls Logo

Alpha CD35C - Page 35

Alpha CD35C
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
Alpha CD25C/28C/35C - Fault Finding
10.4 FAULT FINDING SOLUTIONS A to D
NO
YES
Pump
If pump jammed, release
Replace PCB
NO
PCB - X6 connector, terminals 18, 19
B
Replace pump
1.
2.
240 V ac at:-
Replace PCB
Replace PCB
Replace PCB
Replace transformer
NO
NO
NO
NO
YES
NO
NO
NO
Main terminals L and N
Check electrical supply
Replace fuse
Check wiring
Main terminal fuse
PCB - X1 connector, terminals 55, N
Neon D
illuminated continuously
A
240 V ac at:-
1.
2.
3.
NO
YES
Replace fuse
Neon D illuminated contiuously
Is 240 V ac across
PCB X4 connector terminals 11,12
Is 26 V ac across
PCB X11 connector terminals 40,41
PCB fuse
4.
C
DHW/Primary temp. sensor faulty. Cold resistance approx.
12-14 k ohms (resistance reduces with increase in temp.
i.e. when hot, resistance is approximately 3 k ohms)
Check and correct connections/wiring at sensor and PCB
2.
1.
YES
YES
Check resistance throughout
the range from cold to hot
DHW temperature sensor faulty
i.e. heating OK. Hot water operates
but does not modulate
Primary temperature sensor faulty
i.e. no heating or hot water
Replace sensor
Boiler cycles on and off
Remove the motor from the diverter valve.
Does the piston move in and out when
operating the boiler between CH and DHW
In CH mode. PCB - X5 connector, is 240 V across terminals 15, 16
In DHW mode. PCB - X5 connector, is 240 V across terminals 15, 17
YES
YES
NO
Replace lead
Check continuity of plug and lead
NO
NO
NO
YES
YES
Is diverter valve spindle sticking
D
Check and correct:-
1. Electrical connections
2. Restriction in flue
Neon A and B flashing
at the same time
YES
YES
(BUT)
1.
Replace PCB
Ensure by-pass slot is in horizontal position
and that the valve is not stuck open
Replace diverter valve
Replace PCB
Replace PCB
Replace motor
YES
NO
NO
2.
3.
3.
Fan connections correct at fan and PCB connector X12
Fan runs at maximum speed
PCB connector, is 36 V dc across terminals 39 and 37 or 38
Fan jammed or faulty winding
Is dc volts at PCB, X12 connector:-
across terminals 35 and 37 - 34 V dc
across terminals 36 and 37 - 4 V dc
YES
YES
YES
Replace fan
Replace fan

Other manuals for Alpha CD35C

Related product manuals