Alpine 1310R - Page 15

Wey4-7 Vale
Setting the PI in the Preset Memory
1. Tune in an RDS station and set the display to the station name display.
2. Press one of Preset buttons 1 to 6 for two seconds.
3. The station name flashes for 5 seconds. Press the Preset button at which you want to >
store the P! while the display is flashing. The Pl is now stored in the memory.
4. Set other Preset buttons in the same way.
lf a Preset button at which a PI is stored is pressed, the station name will be displayed.
¢ If the same PI program cannot be received at the first preset recall, "AF SEEK"
operation will be executed automatically.
¢ Incase of bad reception condition at the first preset recall, press the preset button
again and "PI SEEK" operation will be executed automatically.
During this operation, "PI SEEK" will be displayed and the broadcasting station of the
same PI and another frequency will be searched.
¢ lf astation broadcasting the same program cannot be tuned in, reception returns to the
original frequency and the preset indicator turns off.
REGIONAL PROGRAM OPERATION
Some broadcast stations will change from normal broadcasting to regional broadcast-
ing for a certain time period.
[Example]
A station A broadcasts the regional program "WDRG" from 9:00 to 10:00 and the
station broadcasts the normal program "WDR2" for the time period except for 9:00 to
10:00.
( p) ()
Regional Program WDRG WDRE 9:00 to 10:00
Normal
Program
WDR2
WDR2
Time
period
except
for
above
P| area code will change when the normal broadcasting is switched to the regional
broadcasting. This operation allows selection of the function which moves to the regional
station or remains in the normal broadcasting.
1. Press the DISP button © for 3 seconds.
2. Press the Preset No. 4 button @ and the dot matrix display shows REG. ON or REG.
OFF.
3. To switch the REGIONAL ON/OFF, press the Preset No. 4 button @.
Moves to Regional Station. Normal Station