Alpine 1310R - Page 14

re) =) 1e7 Vale) p
A.P.1. 1/A.P.1. 2/PS ONLY MODE
This unit has employed two modes of A.P.1I. 1/A.P.I. 2 as automatic tracing systems
and PS ONLY mode as non-automatic tracing system, so use one of the modes depend-
ing upon status of broadcasting networks, reception status, and other environment.
1. Press the DISP button ® for 3 seconds.
2. Press the Preset No. 3 button @ to switch among A.P.I. 1, A.P.I. 2 and PS ONLY.
[A.P.I. 1] Mode
e When the reception status becomes poor, the unit is automatically switched to a
station which provides good reception status.
NOTE:
Under certain conditions of broadcasting stations, the unit will be switched to another
program station for an instant time of period.
[A.P.1. 2] Mode
e |f erroneous operation occurs with A.P.!. 1 mode selected, switch the mode to the
"A.P.1. 2" mode.
NOTES:
1. When switching from a station which provides poor reception condition to the other
station which provides good condition, the MUTE function works to check whether the
switched station is the same station.
2. When moving from the station providing poor reception condition to a good station, the
MUTE function successively works for a specified interval if a station providing good
reception condition does not exist. In such a case, turn off the A.P.I. or try to tune in
another station. -
3. Inthe A.P.I. 2 mode, the AF and PI are checked again to search the AF station without
fail, so, a longer muting period (about one sec) than that in the A.P.I. 1 mode is
necessary.
[PS ONLY] Mode
e The PS ONLY mode executes only the display of broadcasting station name.
¢ In this mode, automatic tracing operation is not executed. Only the manual tracing
operation described below can be executed.
OTHER CONVENIENT FUNCTIONS
Manual Tracing Operation
This operation is used in case of slow tracing in each automatic tracing mode and PS
ONLY mode. In the operation, AF will be searched instantly and the station which
provides good reception condition will be selected.
1. When the A.P.I. button © is pressed for two seconds while in the A.P.1. mode (when
the A.P.I. indicator 4 on the display is on), reception switches to the station included
among the AF data which is broadcasting the same program with the best reception.
2. “AF SEEK" is displayed during this operation.
3. When the operation is completed, "SEEK END" appears on the display.
14