Alpine 1310R - Page 20

: eo) -J==7 Waele)
FM Stereo/Monaural Switching
You can select between the auto switching or monaural only modes for FM reception
by pressing the MONO button ©. In the auto switching mode, you can receive stereo
broadcasts in stereo and monaural broadcasts in MONO. In the monaural mode, you will
receive the broadcast in monaural only, even if the broadcast is in stereo. The monaural
only mode quiets the noisy stereo signal of weaker broadcasts. The ST indicator @ will
not appear while the monaural mode is selected.
Manual and Auto Seek Tuning
Stations can be tuned in using the procedures described below.
1. Select the tuning band (FM1, FM2, MW or LW) with the BAND button ©. The Band
indicator shows your selection.
nee — FM-2 —~ MW > LW 7
2. Decreasing the frequency:
The
frequency
is
decreased
by
one
step
each
time
the
DN
switch
@
is
pressed.
By pressing and holding the switch for at least 0.5 seconds, the unit will automatically
tune the first station it finds in the direction of decreasing frequency.
3. Increasing the frequency:
The
frequency
is
increased
by
one
step
each
time
the
UP
switch
“©
is
pressed.
By pressing and holding the switch for at least 0.5 seconds, the unit will automatically
tune to the first station it finds in the direction of increasing frequency.
Preset Memory Programming
Follow the instructions below to program stations into preset memory:
Select the tuning band (FM1, FM2, MW or LW) with the BAND button @.
Tune in your desired station using manual or auto seek tuning.
Press the Preset button number 1 @ for more than 2 seconds.
The
preset
indicator
and
the
dot
matrix
display
@
will
begin
to
blink.
Press
that
Preset
button again while the display is blinking (within 5 seconds).
The
frequency
you
selected
will
be
placed
into
preset
memory
number
1
and
will
appear in the display.
NOTE:
If
a
preset
memory
has
already
been
set
in
the
same
address,
it
will
be
cleared
and the new station will be memorized.
6. Follow steps 2 — 4 for the remaining presets (2 — 6). Use this procedure for FM1, FM2,
MW and LW. .
ee oe era
de
Auto Memory Preset
1. Select the desired tuning band (FM1, FM2, MW or LW) with the BAND button @. The
Band indicator shows your selection.
NOTE:
The
auto
memory
preset
procedure
is
allowed
in
the
D.A.P.
mode.
2. Press the A. MEMO button @ for over 2 seconds.
20