Alpine CDE-152E - System Setup Configuration

17-EN
*2 PLAY MODE can be selected in this mode. For details, refer
to page 18.
*3 Refer to page 20.
*4 The setting items are the same as iPod setting in SETUP
mode. For details, refer to page 18.
*5 AUX NAME can be selected in this mode. For details, refer to
page 18.
Notes
•Press r to return to the previous mode.
• Pressing and holding r for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Setting
You can flexibly customize the unit to suit your own preferences and
usage. From the SETUP menu, GENERAL Setting, DISPLAY Setting,
etc., can be modified.
1 Press and hold AUDIOSETUP for at least 2 seconds to
activate the SETUP mode.
2 Turn the Rotary encoder to select the desired item, and
then press ENTER.
(e.g. Select GENERAL)
AUDIO
*1
 GENERAL  DISPLAY  iPod
*2
GENERAL:
CLOCK ADJ
*3
 AUX SETUP
*4
 AUX NAME
*5
 PLAY MODE
 DEMO MODE
DISPLAY:
TEXTSCROLL
iPod:
iPod LIST
*1 Refer to page 12.
*2 CDE-152E/CDE-151E only.
*3 Refer to page 8.
*4 Not displayed when the current source is AUXILIARY.
*5 Displayed only when AUX SETUP is set to ON.
3 Turn the Rotary encoder to select a setting item, and then
press ENTER.
(e.g. Select AUX SETUP)
4 Turn the Rotary encoder to change the setting, and then
press ENTER.
(e.g. Select AUX ON or AUX OFF)
5 Press and hold AUDIOSETUP for at least 2 seconds to
return to normal mode.
Notes
•Press r to return to the previous mode.
• Pressing and holding r for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
SETUP
Use steps 1 to 5 to select one of the SETUP modes to modify.
See the applicable section below for details about the
selected SETUP item.
AUDIO/SETUP
SOURCE/

/ENTER

Rotary encoder
00ALPINE.book Page 17 Monday, November 11, 2013 3:28 PM