Alpine CDE- 9828RB - Description of IC Terminal; Cde-9828 Rb;Cde-9827 R; Cde-9827 Rm;Cde-9827 Rr

CDE-9828RB/CDE-9827R/
CDE-9827RM/CDE-9827RR
Descri
p
tion of IC Terminal
M30626FHPGP : IC501
No. Symbol I/O Terminal Description
1 NC - No connect terminal.
2 REMOCON DATA I Remote control input terminal.
3
I
5
6 GND(BYTE)
7 GND(CNVss)
8
9
10 RESET I System RESET input terminal.
11 6MHz O Crystal OSC connect terminal for main system clock OSC.
12 GND - GND terminal.
13 6MHz I Crystal OSC connect terminal for main system clock OSC.
14 VCC - Power supply terminal.
15 NMI - Pull-up connect terminal.
16 8V-DET I 8V ON detection input terminal.
17 ACC-DET I ACC ON detection signal input terminal.
18 BATT-DET I BATT ON detection signal input terminal.
19 NC - No connect terminal.
20 V-CONT(BATT 3.3V CONT) O CD BATT 3.3V power supply control signal output terminal.
21 AMSD O SEEK STOP detection input terminal at AM. (H:Station ON)
22 NC - No connect terminal.
23 PULL-DOWN - Pull-down connect terminal.
24 CD RST O System RESET output terminal to CD u-COM. (Set up L at initialized.)
25 CD STBY O Active stand-by request signal output terminal to CD u-COM.
26 NC - No connect terminal.
27 PULL-DOWN - Pull-down connect terminal.
28 NC - No connect terminal.
29 RDS MON TXD O RDS Monitor output terminal.
30 RDS MON RXD I RDS Monitor input terminal.
31
32
33 CD CMD O Serial DATA output terminal to CD Mechanism.
34 CD STS I Serial DATA input terminal from CD Mechanism.
35 CD SCK O CD SCK output terminal.
36 LCD CE O Chip enable signal output terminal to LCD Driver.
37 LCD INH O INH signal output terminal to LCD Driver.
38 NC - No connect terminal.
39 NC(PULL-UP) - Pull-up connect terminal.
40 NOSE PWR O NOSE arround power supply control signal output terminal.
41 LCD STB O Shift register signal output terminal.
42 LCD DO O Serial DATA signal output terminal to LCD Driver.
43 LCD DI I Serial DATA signal input terminal from LCD Driver.
44 LCD CLK O Serial clock signal output terminal to LCD Driver.
45 ENCODER2 I Encoder-2 input terminal.
46 ENCODER1 I Encoder-1 input terminal.
47 NC - No connect terminal.
48 PWR IC ON O POWER-IC stand-by control signal output terminal.
NC - No connect terminal.
NC - No connect terminal.
-
- GND terminal.
32.768kHz(NC) No connect terminal.
All manuals and user guides at all-guides.com