Alpine HCE-RCAM-WRA - Wiring Diagram: OEM Head Unit With SGS-CH01 & KCX-C2600 B (Sold Separately)

Jeep Wrangler
HCE-RCAM-WRA  14/16
Wiring Diagram: OEM Head Unit With SGS-CH01 & KCX-C2600B (Sold Separately)
To Factory Main
Harness Connector
To Factory Harness
To SGS-CH01
Main Connector
IN OUT
SGS-CH01
(Sold Seperately)
Factory Head Unit
To Factory
Camera Connector
To Rear
Camera Input
CAM TRIG
KCX-C2600B
(Sold Separately)
Reverse Out (Orange/Black)
Reverse In
(Orange/White)
Accessory (Red)
Battery (Yellow)
Ground (Black)
1 2 3 4 5 6
1 - V. Out
2 - Other Camera
3 - Front Camera
4 - Rear Camera
5 - Switch
6 - Power Wires
Alpine Direct Front Camera
Toggle Switch
NOTE: The HCE-C1100 can NOT be plugged in directly. It must be used with the Power & Video unit
and plugged in with the RCA.
To Chassis Ground
To Red Pin 4
To Orange/White Pin 1
To Yellow Pin 1 of
SGS-CH01 Main Connector
Orange/Black
Power & Video
Unit
Camera Extension Cable
HCE-RCAM-WRA
NOTE: It is highly recommended to
use an Alpine direct connect camera
for the front camera. Any other camera
can not be guaranteed to work.
Ground (Black)
Accessory (Red)
To Red Pin 4
To Chassis Ground
Solder these wires to the rear
camera connector wires. Refer to
the SGS-CH01 manual to see the
pin outs.