Alpine iLX-F509 - Function and System Configuration

ALPINE iLX-F509 68-41657Z87-A_QRG (EN)
16-EN
2 Connect all other leads of the unit
according to details described in the
“Connections” (page19).
3 Mounting the unit in a car.
• Fix the cables carefully. Do not damage them by tucking
them into movable parts, such as a seat rail, or by
locating them against sharp or pointed edges.
Installing the Unit (iLX-F509/iLX-F511)
1 Mount the original mounting bracket to the
main unit using the supplied screws.
• If you do not have the original mounting bracket,
mount the Double din KIT* (provided with the
side mounting bracket), etc. to the main unit.
* Sold separately.
Screws (M5 × 8)
(included)
Original Mounting
Bracket
2 Connect all other leads of the main unit
according to details described in the
“Connections” (page19).
3 Mount the unit in a car.
• Fix the cables carefully. Do not damage them by
mounting them into movable parts, such as the seat rail,
or by locating them against sharp or pointed edges.
Adjust the up-down position of the
Display unit (iLX-F509/iLX-F511)
Adjust the up-down position of the display according
to the mounting position on the vehicle before
mounting the display unit.
Default setting: 0 mm
1 Remove the 4 screws on the rear of the
display unit, then adjust the up-down
position.
Screws (M2.6× 8)
2 Attach the Sheet Rear in a position that
aligns with the up-down position of the
display unit.
Sheet Rear
(Included)
up-down position
2×50 mm: for up-down position 0 mm or -60mm
2×35 mm: for up-down position -15 mm or -45mm
2×20 mm: for up-down position -30 mm
0 mm
Sheet Rear
(2×50 mm)
-15 mm
Sheet Rear
(2×35 mm)
-30 mm
Sheet Rear
(2×20 mm)
Sheet Rear
(2×20 mm)
-45 mm
Sheet Rear
(2×35 mm)
-60 mm
3 Attach the Cover Rear to the rear of the
displa
Secure the screws, then attach the Sheet
caps.
Install the display unit (iLX-F509/
iLX-F511)
1 Fix the Display unit to the slider of the main
unit using 4 scr