21-EN
Turning Mute Mode On/Off
If a device having the interrupt feature is connected,
audio will be automatically muted whenever the interrupt
signal is received from the device. This function can be
turned ON or OFF from the head unit by following
procedure below.
1 Press and hold the F/SETUP button for at least 2
seconds. The display changes to the SETUP screen.
2 Move the Flipper switch up or down to select MUTE.
Press the OK button or MODE knob to set.
3 Move the Flipper switch up or down to select ON or
OFF. Press the OK button or MODE knob to set. The
display returns to the SETUP screen.
NOTE
The initial setting at the factory is "MUTE ON."
4 When the setting is completed, press the F/SETUP
button to return to the normal mode.
NOTE
When Mute is set to OFF, if an external interruption (e.g.,
vehicle phone) happens, the display shows “INT.”.
When Mute is set to ON, the display shows “MUTE”.
Adjusting Source Signal Level
If the difference in volume level between the CD player
and FM radio is too great, adjust the FM signal level as
follows.
1 Press and hold the F/SETUP button for at least 2
seconds. The display changes to the SETUP screen.
2 Move the Flipper switch up or down to select FM
LEVEL.
Press the OK button or MODE knob to set.
3 Move the Flipper switch up or down to select HIGH or
LOW. Press the OK button or MODE knob to set. The
display returns to the SETUP screen.
4 When the setting is completed, press the F/SETUP
button to return to the normal mode.
Demonstration
This unit has the Demonstration feature which simulates
the display functions on the display panel.
1 Press and hold the F/SETUP button for at least 2
seconds. The display changes to the SETUP screen.
2 Move the Flipper switch up or down to select DEMO.
Press the OK button or MODE knob to set.
3 Move the Flipper switch up or down to select ON or
OFF. Press the OK button or MODE knob to set. The
display returns to the SETUP screen.
If no buttons are pressed 30 seconds after the DEMO
mode is turned ON, the DEMO mode then begins.
NOTES
• The initial setting at the factory is "DEMO ON".
• The demonstration operation will repeat automatically until
the DEMO mode is changed to OFF.
4 When the setting is completed, press the F/SETUP
button to return to the normal mode.
4 When the setting is completed, press the F/SETUP
button to return to the normal mode.
5 To adjust the volume, etc., first press the SOURCE/
POWER button and select the AUX mode, then make
the necessary adjustment.
NOTE
When using the Versatile Link Terminal (KCA-410C), you can
connect two external inputs. To select the mode, press the BAND/
TEL. button on the unit.
To Next Page
Loading...
