77-EN
How to use a Seal
If A is used for installation:
Affix the seal so that mounting holes B and C are covered.
If B is used for installation:
Affix the seal so that mounting holes A and C are covered.
If C is used for installation:
Affix the seal so that the mounting holes A and B are covered.
Installing the Face Plate
*
2
If A is used, the supplied face plate may be mounted.
If B is used, the face plate must be modified before installing it.
To modify the face plate, consult your Alpine dealer.
If C is used, the face plate cannot be mounted. Consult your Alpine
dealer.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
4
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the IVA-W505R/
IVA-W502R and put the Rubber Cap on the hex bolt.
If your vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
1
) already
attached to the vehicle’s chassis. Connect all the
leads of the IVA-W505R/IVA-W502R according to
details described in the CONNECTION section.
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
5
Slide the IVA-W505R/IVA-W502R into the dashboard
until it clicks. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard.
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
*
2
*
1
This unit
Bracket keys
(Included)
To Next Page
Loading...
