EasyManua.ls Logo

Alpine iXA-W404R - Auxiliary Device (Optional); Operating Auxiliary Devices (Optional)

Alpine iXA-W404R
71 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
47-EN
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of iXA-W404R (AUX mode) or to the Bluetooth interface
connector by using an optional conversion cable (KCE-237B) (AUX+
mode), follow the procedure described below.
If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
1
Press
SOURCE to activate mode switching
screen.
2
Slide the display horizontally with your finger to
select Audio/Visual mode.
Each time you slide the display, the mode switches
circularly in the following order:
Audio/Visual Navigation Camera Telephone
Multi Info Audio/Visual
3
Slide the display vertically with your finger, or press
SOURCE repeatedly to select AUX* or AUX+
source.
* The name which is given as the source name in Setting the AUX
Mode” on page 23 is displayed.
4
Press /ENTER.
The AUX or AUX+ source is activated and the display
changes to the external input screen.
5
Touch [NTSC/PAL] to change the video input.
If the AUX source is not displayed on the main menu, set AUX IN to
ON by following
“Setting the AUX Mode” (page 23).
If the AUX+ source is not displayed on the main menu, set AUX+ IN
to ON by following
“Setting the AUX+ Mode” (page 24).
The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in
“Switching the Visual Input
Signal System” on page 23.
The display mode changes by touching [WIDE].
For operation, refer to “Switching Display Modes” on page 17.
After connecting the KCA-410C, its AUX input can be used only in
INTERRUPT MODE. For details, refer to the KCA-410C Owner’s
Manual.
Auxiliary Device
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the iXA-W404R correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the iXA-W404R is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.

Table of Contents

Related product manuals