Alpine PSS-24WRA - Front Speaker Removal and Installation

Jeep Wrangler
PSS-24WRA V20211025  5/15
1 Unclip and remove the panel below the steering
column.
3 Unclip the steering column shroud then set aside.
5 Remove the (2) Phillips screws securing the radio
trim panel, then unclip and remove.
2 Remove the (2) Phillips screws exposed.
4 Unclip, unplug, and remove the climate control
panel.
6 Extract the (4) 7mm, screws from the factory radio,
disconnect and remove it.
Front speaker removal and installation