Alpine UTE-200BT - Connecting a USB Device; Connecting Other Portable Audio Device; Listening to the Radio

12-EN
ALPINE CDE-201R 68-40368Z03-C (EN) 128x182
Using R
Setting
and tra
AF continu
strongest
current tr
a
(TP) if rece
1 Press
secon
[GEN
E
2 Rotate
then p
3 Rotate
[TA ON
press
To store
setting
You can p
setting. S
e
automatic
manually,
To receiv
With AF o
will auto
m
selected s
To adjust
announc
Level will
traffic an
n
regular vo
To stay w
(REGION
When the
you will n
o
station wi
this regio
n
[REGIONA
reception
This func
t
other area
Connecting a USB Device
1 Turn down the volume on the unit.
2 Connect the USB device to the unit.
To connect an iPod/iPhone, use the USB
connection cable for iPod (not supplied).
(CDE-203BT/ UTE-200BT only)
Connecting Other Portable Audio
Device
1 Turn off the portable audio device.
2 Turn down the volume on the unit.
3 Connect the portable audio device to the
AUX input jack (stereo mini jack) on the
unit with a connecting cord (not
supplied)
*
.
* Be sure to use a straight type plug.
4 Press SOURCE to select [AUX].
To match the volume level of the
connected device to other sources
Start playback of the portable audio device at a
moderate volume, and set your usual listening
volume on the unit.
Press and hold
/SETUP for at least 2 seconds,
then select [AUDIO]
[AUX VOL] (page 21).
Listening to the Radio
Listening to the Radio
To listen to the radio, press SOURCE to select
[TUNER].
Storing automatically
1 Press /A.ME to change the band (FM1,
FM2, FM3, MW or LW).
2 Press and hold /A.ME for at least 2
seconds.
The unit stores stations in order of frequency
on the number buttons.
Tuning
1 Press /A.ME to change the band (FM1,
FM2, FM3, MW or LW).
2 Perform tuning.
To tune manually
Press and hold
/ to locate the
approximate frequency, then press
/
repeatedly to finely adjust to the desired
frequency.
To tune automatically
Press
/ .
Scanning stops when the unit receives a
station.
Storing manually
1 While receiving the station that you want
to store, press and hold a number button
(1 to 6) until [MEM] appears.
Receiving the stored stations
1 Select the band, then press a number
button (1 to 6).