Alpine UTE-204DAB - Audio System Noise Prevention; Microphone Installation and Safety; Installing the Microphone and Cord Routing

39-EN
EN
FR
ES
DE
IT
SE
NL
RU
PL
ALPINE CDE-205DAB 68-40368Z04-B (EN) 128x182
of your
ontrolling
ot use this
gnal
ehicle’s
.
er control
.
post of
(Green)
(Green/
d (White)
d (White/
ad (Grey/
ad (Grey)
ad
ad
d)
To prevent external noise from entering
the audio system.
• Locate the unit and route the leads at least
10 cm away from the car harness.
• Keep the battery power leads as far away
from other leads as possible.
• Connect the ground lead securely to a bare
metal spot (remove any paint, dirt or grease
if necessary) of the car chassis.
• If you add an optional noise suppressor,
connect it as far away from the unit as
possible. Your Alpine dealer carries various
noise suppressors, contact them for further
information.
• Your Alpine dealer knows best about noise
prevention measures so consult your dealer
for further information.
Installing the microphone (CDE-
205DAB/ UTE-204DAB only)
To capture your voice during handsfree calling,
you need to install the microphone
.
Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or shift
lever. Be sure to keep it and other parts from
interfering with your driving operations.
• If airbags or any other shock-absorbing
equipment is in your car, contact the store
where you purchased this unit, or the car
dealer, before installation.
Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.