Jeep Wrangler
X409-WRA-JL 20200825v1
13/29
Installation Instructions (Continued)
7 If you are using the optional SiriusXM tuner, Cable
tie the module on top of the source unit.
8 For vehicles with heated seats or the power
inverter attach the Power Inverter bracket using
the supplied (2) M5X10LMM screws and lock
washers. This will mean you will not use two of the
M5X8LMM screws from the previous page. These
two screws are slightly longer and can make it
through both brackets.
9 Use the factory speed clips from the bracket that
was removed from the vehicle and attach them to
the Power Inverter bracket. For the Wrangler JL
use the 2 holes circled in black. For the Gladiator
JT use the 3 holes pointed out by the arrows.
10 After attaching the factory speed clips this is what
the bracket will look like for the Wrangler JL.
To Next Page
Loading...
