Alpine X902D Series User Manual

5 Turn off vehicle's ignition, remove the USB memory and turn the ignition back on to
finalize the software update. Please check the firmware version number in
SETUP>GENERAL>ABOUT of the Alpine unit, If “5.0000.5.0000.5.0000” is displayed the
update has succeeded.
Alpine Electronics, Inc.
Update procedure Audio Step 2
Now, download the “xxxx_USB-Stick-2_Audio.zip“an follow the instructions. The
X902D / X802D-U / INE-W710D can be updated via USB connection (see connection
diagram below). Before starting to update, please check following notes. The
download file is compressed in zip format. The contents of the download need to be
extracted to a freshly formatted USB memory (FAT32).
1 Save the downloaded unzipped folder „xxxx” to the empty USB memory on the Root
of the drive.
4 When the software update is finished, the Alpine Unit will restart automatically.
If the Alpine unit shows the update screen again, please push the “Cancel” button.
2 Connect USB memory to USB connector of the Alpine Unit.
Root
6 Reset the Alpine Unit by clicking Setup  General  About  Reset
Update file contents / storage place (for each type of unit)
USB connector
Alpine Unit
USB Connection
USB memory
USB extension cable
Install update software
* Please
see lower left figure.
3 Press “OK” button when update message appears on the screen.
* Please wait 20 seconds for the update to Start.
※
Update will be completed in approx. 3 minutes.
Alpine INE-W710D: NE00007A
Alpine INE-W710DC: NE00007A
Alpine X802D-U: NE00006A
Alpine X802DC-U NE00006A
Alpine X902D-G7: WE00011A
Alpine X902D-G6: WE00011A
Alpine X902D-OC3: WE00011A
Alpine X902D-DU: WE00011A
Alpine X902D-ID WE00011A
Alpine X902D-F WE00011A
Alpine X902DC-F WE00011A
Alpine X902D-S906 WE00011A
Alpine X902D-V447 WE00011A
X902D / X802D-U / X702D / INE-W710D Series
software update procedure
Notes
• Do NOT use the compressed file for update, the Unit cannot recognize compressed (zipped) files.
• Do NOT change folder name and file names, otherwise the Unit will not recognize the files.
• Do NOT put the folder into another folder.
• Do NOT store any other folders/files on the USB memory.
• Do NOT remove the USB memory while updating.
• Do NOT update while driving.
• Do NOT press any buttons while updating.
• Do NOT turn off vehicle’s ignition or head unit’s power switch while updating.
Modern vehicles will shut down the ignition (ACC) after some time if the engine is not running.
If you are not sure if this applies to your car, leave the engine idling while the update is in progress.

Alpine X902D Series Specifications

General

Brand	Alpine
Model	X902D Series
Category	Car Receiver
Language	English