Alstom FKG1X - Page 145

Installation
Measuring main circuit resistance
G31
-
-4
01EN02
8/10
02--2011
© ALSTOM 2010. All rights reserved. Informat
ion contained in
this document is indicative only. No
representati
on or
warrant
y is
given or should
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
ty and
is subject to
change without notice. Reproduction, use or disclosure to
third parties, without express writt
en authority, is
strictly prohibited.
 GRID
Flexible
connectio
ns
Process
The
ALSTOM
supply
being
restricted
to
the
end
pads
of
appara
tus,
flexible
connections and bolting hardware excluded, this manual does not give any
reg
ula
tion
s
con
cer
nin
g
the
con
tact
res
istan
ce
exi
stin
g
betw
een
the
pad
s
and
these connections.
Howev
er, the attention is pointed out
on the importance lying with t
he quality
of these contacts, which depends on the assembling conditions (surface
con
ditio
n,
tigh
teni
ng
torq
ue
for
scre
ws
and
bol
ts)
and
hav
ing
thes
e
con
diti
ons
maintened times goes.
For more information purposes, no total contact resistance should exceed
0.5
m
Ω
.