© ALSTOM 2010. All rights reserved. Informat
this document is indicative only. No
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
change without notice. Reproduction, use or disclosure to
third parties, without express writt
once the contact surfaces have been prepared.
Fasten the connections between circuit--breaker and busbar using screws,
tighten to the appropriate torque.
With regards junctions crossed by the installation’s rated current, contact
resistance/braid must not exceed 0,5
This measure will be realized before all commissioning.
To Next Page
Loading...
