Alstom FKG1X - Page 154

Installation
Connec
tion
with preparation of
electri
cal contact
surfac
es
G31
-
-5
01EN04
7/8
02--2011
© ALSTOM 2010. All rights reserved. Informat
ion contained in
this document is indicative only. No
representati
on or
warrant
y is
given or should
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
ty and
is subject to
change without notice. Reproduction, use or disclosure to
third parties, without express writt
en authority, is
strictly prohibited.
 GRID
Pre
par
atio
n
befo
re
ass
emb
lage
of
alu
min
ium
allo
y
and
alum
iniu
m
allo
y
with
out
coating
(contined)
Grease used
The
electrica
l
contact
grease
consists
of
a
mixture
of
:
50 % neutral Vaseline (-01835106)
and
50 % ”Contactal” grease (-01835118)
To ensure that this mixture is clean, it is preferable to prepare and stock it in
tubes.
A
small
quantity of
this
mixture
should be
applie
d
to
the
prepare
d
surface,
spread out, then wiped over using a clean cloth, so that only a thin layer re-
mains.