CommissioningCommissioning
Pre-commissioning inspectionsPre-commissioning inspections
G34-001EN04 G34-001EN04
Commissioning test reportCommissioning test report
RES337EN003 RES337EN003
Acceptance criteriaAcceptance criteria
CA400321-3EN006 CA400321-3EN006
Maintenance planMaintenance plan
G51-001EN07 G51-001EN07
Electrical wear limitsElectrical wear limits
G51-051EN03 G51-051EN03
Electrical contact densimeter threshold inspectionElectrical contact densimeter threshold inspection
G51-101EN03 G51-101EN03
Replacing the electrical contact densimeterReplacing the electrical contact densimeter
G51-161EN02 G51-161EN02
Replacement of enclosure cover sealsReplacement of enclosure cover seals
G51-202EN06 G51-202EN06
Disassembly and assembly of the GCB equipmentsDisassembly and assembly of the GCB equipments
G51-500EN01 G51-500EN01
TroubleshootingTroubleshooting
G52-001EN03 G52-001EN03
Tooling and accessoriesTooling and accessories
G60-001EN14 G60-001EN14
Installing short-circuit barsInstalling short-circuit bars
G61-001EN06 G61-001EN06
Dismantling and recovery of components from a Dismantling and recovery of components from a
circuit breakercircuit breaker
G80-000EN02 G80-000EN02
Management of SF6 gasManagement of SF6 gas
G80-001EN02 G80-001EN02
Instructions on the handling of used SF6 gas and decomposition productsInstructions on the handling of used SF6 gas and decomposition products
G81-001EN03 G81-001EN03
General arrangementGeneral arrangement
VS133690GAD03D VS133690GAD03D
Elementary diagramElementary diagram
VS133690EDD03D VS133690EDD03D
Nameplate engravingNameplate engraving
VS133690NPD03D VS133690NPD03D
SF6 pressure scale SF6 Elementary diagramSF6 pressure scale SF6 Elementary diagram
VS133690SPD03D VS133690SPD03D
Interlocking diagramInterlocking diagram
VS133690IDD03D VS133690IDD03D
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or
should be relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercialshould be relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial
circumstances. It is provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties,circumstances. It is provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties,
without express written authority, is strictly prohibited.without express written authority, is strictly prohibited.