EasyManuals Logo

Alstom GEM80-400 Series User Manual

Alstom GEM80-400 Series
325 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
GEM80-400 Safety Instructions
Issue 3 04/99 ALSPA GEM80-400 SERIES CONTROLLERS TECHNICAL MANUAL Page iii
SAFETY INSTRUCTIONS
1. General
Electrical equipment represents a risk to life.
Safety instructions are given on the product, in this manual and other relevant
manuals referred to in this manual.
Reference must be made to the instructions in this manual for any action taken
when transporting, commissioning, operating, maintaining and disposing of the
product.
Dangerous voltages appear on the circuitry. There can be moving parts and hot
surfaces. Death, severe physical injury and extensive material damage can result
if the instructions given in this manual are not observed.
Local safety regulations must be observed during erection, commissioning and
maintenance of the product. Persons performing this work must be suitably
skilled and should have been trained in that work for these products.
Electrostatic sensitive components are used within this product. Static handling
precautions in accordance with Protection of Electrostatic Sensitive Devices,
Part 1, General Requirements, EN 100015 Pt.1:1992 (CECC 00015:1992) must be
observed.
All products weighing in excess of 20 kg (44 lbs) should be moved by mechanical
handling equipment using the lifting points provided.
Radio transmitters (e.g. walkie talkies, mobile telephones) can cause incorrect
operation. Transmitters with an output of more than 2 watts must not be used in
the vicinity of the product. Transmitters with output power of 2 watts or less must
not be used less than 2 metres (6 feet) from the product.
2. Intended use
These products are components designed for incorporation in installations,
apparatus and machines.
In the European Union, a machine should not be taken into service until the
machine has been proven to conform with the provisions of the Machinery
(Safety) Directive, 89/392/EEC as amended.
In the European Union, the requirements of the EMC Directive, 89/336/EEC, and
any amendments to that Directive should be established before any installation,
apparatus or machine which incorporates the product is taken into service.
The product complies with the requirements of the Low Voltage Directive,
73/23/EEC as amended.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alstom GEM80-400 Series and is the answer not in the manual?

Alstom GEM80-400 Series Specifications

General IconGeneral
BrandAlstom
ModelGEM80-400 Series
CategoryController
LanguageEnglish